Maintenance - Dimplex DS2205 Service Manual

the remote casing and battery cover (Figure 3).
Remote Operation
!
NOTE: Ensure that the stove 3-Position Switch is set to
the remote control setting.
To operate, push the On button to turn stove On, push the
Off button to turn the stove off.
Remote Control Initialization/Reprogramming
If the remote control or remote control receiver has been
replaced, follow these steps to initialize the remote control
and receiver:
1. Set the 3-Position switch to OFF.
2. Wait a minimum of five (5) seconds and set the 3
Position Switch to the position (Figure 1A).
3 . Within 10 seconds of re-acquiring power, press the ON
button located on the remote control.
!
NOTE: You will have only 10 seconds to perform this
last step. Failure to do so will result in these steps needing
to be followed again.
This will synchronize the remote control and receiver.
battery Replacement
To replace the battery:
1. Slide battery cover open on the remote control
(Figure 3).
2. Install one (1) 12-Volt (A23) battery in the battery
holder.
3. Close the battery cover
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for
recycling advice in your area.

MAINTENANCE

WARNINg: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of fire,
electric shock or damage to persons.
Light bulb Replacement
Allow at least 10 minutes for light bulbs to cool off before
touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark
section of the flame or when the clarity and detail of the log
exterior disappears. There are two bulbs under the log set
which generate the flames and embers.
Tool Requirements: Phillips screw driver
helpful hints: It is a good idea to replace all light bulbs
at one time if they are close to the end of their rated life.
Group replacement will reduce the number of times you
need to open the unit to replace light bulbs.
Light bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs
with an E-12 (small) socket base, 25 Watt rating.
bulb Replacement
Depending on the unit there are two different types of ac-
4
cess to the light bulbs for changing.
Through the front door:
1. Open the front door.
2. Remove the four (4) screws located on the ember
bed and remove the log set (Figure 4).
3. Locate and examine the bulbs to determine which
bulb(s) required replacement.
4. Unscrew the bulb(s) counter clockwise.
5. Insert new bulb(s).
6. Install the log set into the unit. Replace the log set
retaining screws into the ember bed.
Through the access panel on the back of the unit:
1. Remove the five screws from the access panel,
located on the back of the unit, and remove access
panel.
2. Locate and examine the bulb to determine if
replacement is required.
3. Unscrew the bulb counter clockwise.
4. Insert new bulbs.
5. Secure access panel to unit.
Clear Door Panel Cleaning
The clear door is cleaned in the factory during the assembly
operation. During shipment, installation, handling, etc.,
the clear door may collect dust particles. These can be
removed by dusting lightly with a clean, dry cloth.
To remove fingerprints or other marks, the clear doors
can be cleaned with a damp cloth. The clear door should
be completely dried with a lint free cloth to prevent water
spots. To prevent scratching, do not use abrasive cleaners
or spray liquids on the clear door surface.
Compact Stove Surface Cleaning
Use warm water only to clean painted surfaces of the
Compact Stove. Do not use abrasive cleaners.
Servicing
Except for light bulb replacement and cleaning described
above, an authorized service representative should perform
any other servicing.
Figure 4
www.dimplex.com