Volvo D13 User Manual page 43

pressure regulator output. The pressure
regulator is mounted in the upper section of
engine compartment
accessible through the engine compartment
R.H. side door.
29. On vehicles equipped with an electrically
operated cold-starting aid, disconnect the
delivery hose from the starting-aid cylinder
solenoid valve. Remove cable ties securing
hoses.
30. Disconnect the
(Allison: 2 main connectors, 1 connector to
the retarder accumulator solenoid) (ZF
transmission: 3 connectors).
31. From under the vehicle, disconnect the
propeller shaft as detailed in Section 09,
under heading "Propeller Shaft Removal".
32. Inspect the power plant assembly to ensure
that nothing will interfere when sliding out the
cradle. Check for connections or hoses not
mentioned in this list as some vehicles are
equipped with special
components.
33. Remove the six retaining bolts, washers and
nuts securing the power plant cradle to the
vehicle rear subframe (Fig. 23).
NOTE
Check if any spacer(s) have been installed
between power plant cradle and vehicle rear
subframe, and if so, note position of each
washer for reinstallation purposes.
34. Using a forklift, with a minimum capacity of
4,000 lbs (1 800 kg), slightly raise the power
plant cradle.
35. Pull engine out slowly from the engine
compartment. Make sure all lines, wiring and
accessories are disconnected and are not
tangled.
CAUTION
Due to the minimum clearance between the
power plant equipment and the top of the
engine compartment, extreme care should be
used to raise the power plant cradle, just
enough to free the cradle. Clearance between
power plant cradle and mounting rail should
range between 1/4" and 1/2" (6-12 mm).
PA1561
backwall and is
transmission harness
or aftermarket
43
Section 01: ENGINE