S W I T C H I N G O N Y O U R V E R T U P H O N E; Entering Your Pin Code; S E T T I N G T H E T I M E A N D D A T E - Vertu Signature NPM-7 User Manual

S W I T C H I N G O N Y O U R V E R T U P H O N E

0 1
If your battery requires charging, a
is displayed when you first switch on your Vertu phone.
Refer to "Battery" on page 5-3 for more information.
0 2
Contact with the antenna affects call quality and may
cause the phone to operate at a higher power level than
otherwise needed. Avoiding contact with the antenna
area when operating the phone optimises the antenna
performance and battery life.

ENTERING YOUR PIN CODE

Depending on your SIM card settings, you may be
prompted to enter a PIN (Personal Identification Number)
code when you switch on your Vertu phone. This code is
used to protect access to your SIM card and is
independent of your Vertu phone. If you used your SIM
card in another phone previously, the code will be the
same.
It is recommended that you activate both the PIN
code and security code to help prevent unauthorised
use of your SIM card and your Vertu phone. Refer to
"06 Security information" on page 6-1 for more
information.
Press and hold the
P O W E R
>
key (01) for approximately four
seconds to switch on your
Vertu phone.
message
battery low
Your Vertu phone has an
>
internal antenna located inside
the top-rear panel (02). Do not
touch the antenna
unnecessarily when phone is
switched on.
Use the keys to key
N U M B E R
>
in your PIN code.
Press ok .
>
V E R T U

S E T T I N G T H E T I M E A N D D A T E

If the time and date are not set, you are prompted to
enter your time settings when you first switch on your
Vertu phone.
If your Vertu phone was purchased at a Vertu store, the
time and date should already be set for you.
We recommend setting the time and date
immediately to ensure that features which use the
time and date, for example the agenda, operate
correctly.
To set the time and date the first time you switch on your
Vertu phone:
You can enter the time in either 12-hour (AM/PM) format
or 24-hour format.
For example, to set the time to 08:30:
Key in "8".
>
Scroll to minutes. The leading zero is added to the hour
>
figure.
Key in "30".
>
Press ok .
>
Or, to set the time to 12:30:
Key in "12". The cursor automatically jumps to the
>
minutes.
Key in "30".
>
Press ok .
>
0 1 G E T T I N G S T A R T E D
Use the keys to key in
N U M B E R
>
the correct time.
Use the keys to toggle
S C R O L L
>
between hours and minutes.
1-4