Installing A Memory Module - Toshiba Satellite A500 Series User Manual

Use a # 0-point Phillips screwdriver to remove and fasten the screws - the
use of an incorrect screwdriver can damage the screw heads.

Installing a memory module

The computer contains slots for two memory modules, one positioned
immediately over the other - the procedures are the same for installing
either module.
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the memory module cover.
a
b
4. Align the notch of the memory module with that of the memory module
slot and gently insert the module into the slot at about a 45 degree
angle before holding it down until the latches on either side snap into
place.
User's Manual
Turning off the power
1. Memory module cover
2. Screw
3. Slot B
4. Slot A
Figure 8-4 Removing the memory module cover
section in Chapter 3,
Optional Devices
Getting Started if
c
d
8-7