Lan; Wireless Communication Indicator - Toshiba Satellite A500 Series User Manual

Wireless communication indicator

The wireless communication indicator shows the status of the computer's
wireless communication functions.
Indicator status
Indicator off
Indicator glows
If you used the Taskbar to disable the wireless LAN, restart the computer or
perform the following procedure to re-enable it: Click Start, open Control
Panel, click System and Security, click Device Manager on System
category, double-click Network Adapters, and right click the wireless
device then choose Enable.

LAN

The computer has built-in support for Ethernet LAN (10 megabits per
second, 10BASE-T), Fast Ethernet LAN (100 megabits per second,
100BASE-TX) and Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T). This section describes how to connect/disconnect to a LAN.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■
The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■
The Link speed (10/100/1000 megabits per second) changes
automatically depending on the network conditions (connected device,
cable or noise, and so on).
LAN cable types
The computer must be configured properly before connecting to a LAN.
Logging onto a LAN using the computer's default settings could cause a
malfunction in LAN operation. Check with your LAN administrator
regarding set-up procedures.
If you are using Gigabit Ethernet LAN (1000 megabits per second,
1000BASE-T), be sure to connect with a CAT5E cable or higher. You
cannot use a CAT3 or CAT5 cable.
If you are using Fast Ethernet LAN (100 megabits per second, 100BASE-
TX), be sure to connect with a CAT5 cable or higher. You cannot use a
CAT3 cable.
If you are using Ethernet LAN (10 megabits per second, 10BASE-T), you
can connect with a CAT3 or higher cable.
User's Manual
Indication
The wireless communication switch is off. No
wireless functionality is available.
Wireless communication switch is on. Wireless
LAN or Bluetooth is turned on by an application.
Operating Basics
4-51