Table of Contents
Advertisement
After you finish the WAN settings, click Apply to submit your changes.
Figure 4-12 WAN Configuration-Manual Config
LAN Configuration for NAT Routing Mode
The Wireless Routing Center communicates with a LAN through a LAN port. The
LAN configuration page lets you define the private IP address and DHCP server
settings over the LAN interface.
1. In the Manual Config > IP Address/Subnet Mask field, enter
the IP address and subnet mask for the LAN port.
The default LAN port IP address is 192.168.10.1 and the subnet mask is
255.255.255.0. Note that if you change the private IP address and apply the
changes, the computer from which you configure the router will lose commu-
nication to the router. To reconnect, you will need to renew the IP address of
the computer or change to an IP address compatible with the new LAN port IP
address.
2. In the DHCP Server > Service field, select whether to enable DHCP
service on the LAN port.
Configuration for NAT Routing Mode
4-13
Advertisement
Table of Contents
