Start-Up Preferences; Set Clock; Set Units - TomTom Blue&Me- Owner's Manual

Start-up preferences

Tap this button to select what happens when your device starts. The fol-
lowing options are available:
• Continue where I left off - your device starts and shows the last
Start-up
screen that was shown when you turned off the device.
preferences
• Ask for a destination - your device starts with Navigate to... menu
or the list of frequent destinations, if you have set some frequent des-
tinations.
• Show the Main Menu - your device starts with the Main Menu.
• Start Slideshow - your device starts by showing a slideshow of the
images stored there. To interrupt the slideshow, tap the screen.
You are then asked if you want to change the picture that is shown
whenever you start your device.
Tap No to finish or tap Yes to see the photos stored on your device and
tap on a photo to select that photo for use as your start-up picture.

Set clock

Tap this button to select the time format and to set the time.
The easiest way to set the time is by tapping the Sync button. Your
Blue&Me-TomTom will then take the time from GPS information.
Set clock
Note: You can only use Sync if you have GPS reception, so you cannot
set the clock in this way when you are indoors.
After using Sync to set the time, you may have to adjust the hours
depending on your time zone. Your Blue&Me-TomTom works out your
time zone and always keeps the time correct using GPS information.

Set units

Tap this button to set the type of units that will be shown for the follow-
ing:
• Distance
Set units
• Time
• Latitude and longitude
52