Connecting A Wavetable Daughterboard - TerraTec SiXPack 5.1+ Manual

Connecting a Wavetable Daughterboard.

If you own a wavetable module, like TerraTecs WaveSystem for example, a module from an
older TerraTec card (e.g. Maestro Series) or a Yamahas DB50-XG, you can use it on the Sound-
System SiXPack 5.1 + . To do that simply attach the 26 poled connector to the pin row marked
"CN2" (Wavetable Xtention) on the SiXPack 5.1 +. Pay attention that all of the pins are con-
nected with the wavetable module. Both connector rows must be correctly aligned.
Important:
The signal from an attached wavetable daughterboard is routed to-
gether with the AUX signal. These are not separated electronically from
one another. Therefore, simultaneous operation should be avoided
where possible. If you connect two devices to "one line", you will expe-
rience considerable signal loss in both devices. In addition, we cannot
guarantee that this will not have a long-term negative effect on both
devices.
The volume of the wavetable module is controlled at a later stage in the ControlPanel using the
"AUX" controller.
Further information can be found in the section "The Wavetable Connector and the Internal
Synthesizer." (page 47).
10 SoundSystem SiXPack 5.1 +