The I/O Board; Output; S/Pdif Out - TerraTec EWS88 MT Manual

Hide thumbs Also See for EWS88 MT:

Table of Contents

The I/O Board.

However, you should make sure, that the module never becomes de or attached during

operation. It could be damaged.

Here you can adjust the levels (between +4 dBu and -10dBV) for all

outputs of the EWS88 MT. –10 dBV is very common in home-studios

(the signal-levels are comparatively low, which is compensated for

with the higher input-sensitivity). +4 dBu is generally a professional

setting (Instruments are powerful enough and make noise less

prominent, hence the input-sensitivity is acceptable).

Here you determine, whether the signal you are sending via the digital

interface contains security information. It is possible to include a

especially useful when you send out some demo tapes and do not want

(digital) copies made of your composition.

Also included is the newly developed "Non-Audio" mode. Apart from

S/PDIF and ADAT signals, AC3 and DTS signals (i.e. from a software

DVD-player) can be transmitted directly to an external Dolby Digital

Receiver.

An extremely simple feature of

the ControlPanel. In case the

88AX becomes detached from

the card, (this might be possible

with tightened screws though),

the converters must be newly

calibrated. This will take almost

exactly 250ms shouldn't hurt.

AudioSystem EWS88

Table of Contents

Show Quick Links

Table of Contents

Ews88 d