4) Preset and Sample Setting levels and tones will vary depending on the bass, amp
and cabinet you use.They were determined using a "typical" bass and cabinet, and are provided as
a starting point. So, some adjustments may be necessary, particularly to the Level control. For
instance, if you have a high output bass, a clean setting will be louder than a distorted one.
Conversely, a low output bass will require a higher level for a clean setting. If you have a big cabi-
net, the Fat Tube setting will be louder.With a smaller cabinet, the Flip Top setting will be louder.
5) Buffered bypass eliminates the shortcomings associated with "true bypass" (pops and clicks,
and high-end loss when multiple pedals are connected together), as well as signal loss associated
with other types of switching circuits.
6) Custom actuators. All Tech 21 pedals feature smooth, silent-switching actuators that are
licensed by other major manufacturers.
7) REMEMBER THIS WARNING: DO NOT run the speaker output of any amp
directly into the SansAmp. Severe damage to the amp and/or SansAmp may
result.
GLOBAL RESET
To reset your unit back to factory specifications, you can perform the following procedure: Hold
down the footswitches for Channels 1 and 3 while simultaneously applying power (either plugging in
an adapter or, if a battery is installed, plugging in your guitar cable).Then release the switches.
Or, you can reprogram each of the first six Sample Settings:
[Bank A]
(1) Fat Tube
(2) Flip Top-style
®
[Bank B]
(4) SVT
-style
(5) Thumpy Funk
(3) Rage
(6) Fuzzed Out
SAMPLE SETTINGS
FAT TUBE
FLIP-TOP-style
RAGE
®
SVT
-style
THUMPY FUNK
FUZZED OUT
W
T
4