Digital Output; Digital Input - TC Electronic REVERB 4000 User Manual

I/O MENU -
Analog Offset
Input Offset
Range:The range is relative to the set Analog
Max parameter.
The Analog Max parameter sets ideal interface
level to the surrounding environment and adjust
both the Analog Input and Output Max level.
The Analog Input offset parameter is used to
optimize the Input level while keeping the
Analog Max setting.
Output Offset
Range: -20 to +20dB
The range is relative to the set Analog Max
level parameter.
The Analog Output Offset parameter is typically
used if the downstream device has an
operating level that differs from the set Analog
Max setting.

Digital Input

Input Select
Range: AES/EBU, ADAT, Optical.
Selects digital Input type. Digital Input must be
selected.
Digital Input Trim
Range: -24 dB to 0 dB (Step 0.2 dB)
Trim parameter on the digital Input.
Signal is bit transparent at -6, -12, -18 and
-24dB.
Optical
Optical In
Options: Tos-Link, ADAT 1-2, ADAT 3-4,
ADAT 5-6, ADAT 7-8
Select appropriate Optical Input type according
to your setup.
Optical Out
Options: Tos-Link, ADAT 1-2, ADAT 3-4,
ADAT 5-6, ADAT 7-8
Select appropriate Optical Output type
according to your setup.
20
FRONT PANEL OPERATION

Digital Output

Dither
Range: 8, 16, 20, 24, Off
Determines to what bit truncation should be
made. Dither should be applied at the final
stage only and according to the next
downstream device in the signal chain.
Status Bit
Range: S/PDIF, AES/EBU
Determines which Status Bit should be sent out
with the digital signal.