TC Electronic G-Sharp User Manual page 16

Preamp + power amp
This is a basic setup if you are using a
separate power amp for a stereo setup.
• Connect the guitar to the Input of the pre-
amp.
• Connect the pre-amps output to the G-Sharp
input and the G-Sharp outputs to the input of
the stereo amplifier.
• Set Routing to serial or parallel.
• Set Input level to 12 o'clock position.
• Set EFFECTS MIX to 12 o'clock position.
• Set REVERB MIX to 12 o'clock position.
• Adjust/fine-tune the G-Sharp Input level so
the Input LED on the front panel often is
yellow but only rarely peaks at Red color.
• Select Reverb type and Effects type using
the selectors on the front panel.
• Now fine-tune EFFECTS and REVERB mix
as well as parameters.
You can of course add effect pedals in front of
the preamp as you wish.
TYPICAL SETUPS
15