TC Electronic G-Sharp User Manual page 14

Head + cab
This is a basic setup if you are using a
conventional head with serial loop.
• Connect the guitar to the input of the head.
• Connect the effect loop send to the G-Sharp
left input and the G-Sharp left output to the
effect loop return of the amplifiers.
• Set Routing to serial or parallel.
• Set INPUT to 12 o'clock position.
• Set EFFECTS MIX to 12 o'clock position.
• Set REVERB MIX to 12 o'clock position.
• Adjust/fine-tune the G-Sharp Input level so
the Input LED on the front panel often is
yellow but only rarely peaks at red color.
• Select reverb type and Effects type using the
selectors on the front panel.
• Now fine-tune EFFECTS and REVERB mix
as well as parameters.
You can of course add effect pedals in front of
the head as you wish.
TYPICAL SETUPS
The setup is mono but could be expanded to
stereo if the right output of the G-Sharp is
connected to a separate amp.
13