Centre Channel Speaker - Tannoy REVOLUTION Owner's Manual

CENTRE CHANNEL SPEAKER

In all cases the centre channel speaker should be positioned as near to the TV screen as possible. The viewing
position when seated determines the ideal mounting height, but in all cases this should be as close as possible
to ear height. As with the main speakers the front baffle panel should be as near as possible in line with the
screen surface.
The Revolution DC LCR centre channel can be wired in single wire, bi-wire or bi-amp modes. Please refer to figs.
3, 4 & 5 for connection guidance bearing in mind that connection should be made to the dedicated
centre channel output on your A/V processor amplifier/s.
WARNING:
Only use the support platform provided with the Revolution DC4LCR. It is not recommended that speaker
be balanced on top of the tv or plasma screen.
REAR EFFECTS SPEAKERS
The integrity of the special effects soundstage created by the source material will be compromised if the speakers
are installed on the sidewalls, for that reason they should always be placed behind the main viewing position. The
placement of floor standing or stand mounted speakers at the rear should mirror as near as possible the location of
the front pair and 0.5 metres (20 inches) from the rear wall.
SUBWOOFER
As the subwoofer only produces low frequency, therefore monaural information, it is difficult to detect its location
by ear. It could as a result be situated anywhere in the room, but optimum performance will be gained by locating
the subwoofer between the main stereo pair of speakers. Bass output will increase when placed next to a wall or
in a corner so use the subwoofer volume control to balance the output with the rest of the system.
Please refer to the manual supplied with the subwoofer for advice on installation and set-up.
_09
REVOLUTION MANUAL