Advertisement
TN2.600D Pre-Amp
1.
RCA Audio Output Connection
Using high quality shielded stereo RCA cables, connect the
audio signal to the RCA audio inputs of additional system
components.
2.
RCA Audio Input Connection
Using high quality shielded stereo RCA cables, connect the
source signal outputs to the amplifer RCA inputs.
3.
Level Sensitivity
Adjust the amplifers pre-amp sensitivity level. The minimum
sensitivity level is 200mv, while the maximum level is 6V.
4.
Power Indication LED
When the amplifer is on and in proper working condtion, this
LED will illuminate green. Refer to the Troubleshooting Guide
for possible solutions if the amplifer will not power on.
5.
Protection Indicator LED
If the amplifer activates protection mode, this LED will illumi-
nate red. Refer to the Troubleshooting Guide for possible
solutions if the amplifer activates protection mode.
TN2.600D Pre-Amp Panel
6.
High Pass Crossover
Adjust the frequency setting of the High Pass Crossover. The
frequency range is 20Hz-4kHz. Frequencies lower than the
7.
Crossover Frequency Multiplier
Use the frequency multiplier to change the High Pass Crossover
frequency range x10.
8.
Low Pass Crossover
Adjust the frequency setting of the Low Pass Crossover. The
frequency range is 50Hz-5kHz. Frequencies higher than the
9.
Crossover Frequency Multiplier
Use the frequency multiplier to change the Low Pass Crossover
frequency range x10.
10.
Crossover Selector Switch
Choose to activate the High Pass Crossover, Low Pass Crossover,
or Band Pass Crossover. Band Pass Crossover uses the high pass
and low pass crossovers simultaneously.
TN2.600D
Advertisement
