Configuration Settings - Amana DT01 Series Installation Instructions Manual

The PTAC control will automatically self-configure to work with the wall thermostat (DS01* Kit) if installed. The PTAC
control will automatically self-configure to activate pre-configured energy management routine when the DD01* is
installed and bound to the PTAC. Additionally, the setback times and setback temperatures can be changed using the
configuration settings. If you are using DP01* Front Desk Platform, the PTAC control will need to be configured to
identify its room number placement.
Standard and DS01* Configuration
To enter configuration feature mode:
Press and continue to hold the up and down
a two (2) second time frame. (On software versions 2.1 or lower - C1 will now be displayed. On version 2.5 or
higher - you will see " - - " displayed.) Once you are in the configuration program, you can use the HEAT button to
move UP the various configuration settings or the COOL button to move DOWN the configuration settings. The + or
- keys will move up or down the selectable codes that you can change for each configuration setting. Ensure that
you are in the proper configuration setting before pressing the + or - key as you may accidentally change a setting
that you did not intent to change.
The display will alternate between displaying the feature code
in version 2.5 or higher - press the HEAT button one time to get into C1 mode and then the display will alternate be-
tween C1 and 0 - the factory default. If an RF DS01* has been bound to the unit the display will alternate between
C1 and rE.The lower right dot on the display will flash.
Entering Room Number (Skip if not using DP01* Front Desk Platform)
1. The PTAC control can be set for a 4-digit room number. To select the first two digits (floor), press the HEAT
key until appears, then press the up
2. To select the last two digits of the room number, press the HEAT
and down arrows to select the last 2 digits of the room number.
For example for Room "201", press the HEAT
=
select "02":
Next to select the last two digits of the room number, press the HEAT
up and down

Configuration Settings

down arrows to select the first two digits.
.
arrows to select "01":
arrow keys and quickly press the OFF
and the option code
key until appears, then press the up
=
.
7
0
(factory default setting)
key until appears, then press the up
down arrows to
key until appears, then press the
key twice within
.
If