Table of Contents
Advertisement
Quick Links
Introducing the SoundWave 7.1 PCI
The SoundWave 7.1 PCI transforms your PC into a home
theater system with multi-channel surround sound.
Features
•
Compliant with PCI revision 2.2 and PC99
specification
•
Supports 24-bit/96KHz playback, 16-bit/48KHz
recording
•
S/PDIF transmitter supports 44.1/48/96KHz
sampling rate and 16-/24-bit resolution
•
HRTF-based 3D positional audio supporting
DirectSound 3D, EAX and A3D interfaces
•
Supports multi-channel output to 2/4/6/8
speakers
•
8-channel output capability supports the latest
Dolby Digital EX and DTS ES DVD audio format
System Requirements
•
Pentium II 366 MHz or equivalent PC with an
available PCI slot
•
Windows 98SE/ME/2000/XP/Server 2003
•
64 MB system memory
•
CD-ROM or DVD-ROM drive
•
DirectX 9.0 or above (recommended)
04-0360A
SoundWave 7.1 PCI
Quick Installation Guide
1
Advertisement
Table of Contents
Related Manuals for SIIG SoundWave 7.1 PCI
Summary of Contents for SIIG SoundWave 7.1 PCI
- Page 1 SoundWave 7.1 PCI Quick Installation Guide Introducing the SoundWave 7.1 PCI The SoundWave 7.1 PCI transforms your PC into a home theater system with multi-channel surround sound. Features • Compliant with PCI revision 2.2 and PC99 specification • Supports 24-bit/96KHz playback, 16-bit/48KHz recording •...
-
Page 2: Package Contents
Package Contents • SoundWave 7.1 PCI • Software CD (Xear 3D and WinDVD 5.0) • This quick installation guide Layout Aux In CD In Jumpers Figure 1: Layout Note: Leave the jumpers in the default position. There is no need to change this setting. - Page 3 Rear Connectors Front Out: This connector provides front source output, you can connect one set of active speakers or headphone. Rear Out: This connector provides rear sound source output, you can connect one set of active speakers or headphone. C-LFE: This connector provides center and subwoofer (LFE) sound source output, you can connect one set of active speakers.
-
Page 4: Hardware Installation
Hardware Installation General instructions for installing the card are provided below. Since the design of computer cases and motherboards vary, refer to your computer’s reference manual for further information, if needed. Caution: Static Electricity Discharge may permanently damage your system. To avoid possible static electricity discharge during the installation, please follow the guidelines below: •... -
Page 5: Driver Installation
Driver Installation Windows 98SE/ME/2000/XP After installing the board boot up Windows. At the new Add New Hardware Wizard, click Cancel. Insert the software CD, Autorun should start the installation automatically. If Autorun does not start, click Start, Run. Type X:\Auto.exe, then click OK. - Page 6 Follow the on screen instructions to complete the uninstall, then restart your system. Utilities Software Included on the SoundWave 7.1 PCI software CD is Xear 3D and WinDVD. Xear 3D is an audio setup utility for your soundcard. WinDVD is the premiere full-featured software DVD player for Windows PCs.
-
Page 7: Speaker Configuration
WinDVD Installation Insert the software CD. Autorun should start the installation. If Autorun doesn't start, click Start, then Run. Type X:\Auto.exe, then click OK. (Replace X: with the drive letter of your CD-ROM) At the SC8767 installation screen, click Install WinDVD. - Page 8 Click the drop down list and select your speaker type. Click OK to save the settings. Windows XP From the main desktop, click Start, Control Panel. Click Sounds and Audio Devices. Select the Audio tab. Click Advanced under Sound Playback, then click the Speakers tab.
-
Page 9: Troubleshooting
Troubleshooting Q1: I have a 7.1 speaker system connected, only two speakers are working? A1: Go to Control Panel, double click CMI Audio Config. Under Output Device, click the number 8. Q2: Center speaker and Subwoofer are conflicting? A2: Click on the Hammer icon under Output Device in CMI Audio Config. - Page 10 Blank Page...
-
Page 11: Technical Support
The 5-year manufacturer warranty supplied with this product is offered by SIIG, Inc. If you should happen to encounter any problems with this product, please follow the procedures below. - Page 12 Fremont, CA 94538-3152 SoundWave 7.1 PCI is a trademark of SIIG, Inc. SIIG and SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. Pentium is a registered trademark of Intel Corporation. Other names used in this publication are for identification only and may be trademarks of their respective companies.
Need help?
Do you have a question about the SoundWave 7.1 PCI and is the answer not in the manual?
Questions and answers