Table of Contents
Advertisement
3.
Push the board down firmly, but gently, until it is
well seated.
4.
Connect an available 4-pin power connector from
the system power supply to the 4-pin power
connector on the FireWire 800 32-bit PCI board (See
Figure 1 on page 3). This connection is recommended
for consistent power output from the FireWire port.
5.
Secure the card and replace the cover.
Software Installation
This section provides information on how to install the
FireWire 800 32-bit PCI drivers. Please follow the directions
below for your operating system.
Windows 2000
Windows 2000 automatically installs it's built-in FireWire
400 driver for the FireWire 800 32-bit PC. To get the full
speed out of this controller, install the Firewire 800 driver
using the directions below.
1.
Insert the driver CD. Click Start, then click Run.
Type D:\setup.exe, click OK. (Change D: to match
your CD-ROM drive letter)
2.
At the Welcome screen, click Next.
3.
At the License Agreement screen, click Yes.
4.
Type in your customer information, then click Next.
5.
At the Destination Location screen, click Next.
6.
Select Complete, then click Next.
7.
At the Select Program Folder screen, click Next.
8.
At the Digital Signature screen, click Yes, then click
Finish.
9.
Select the restart Windows option, then click Finish.
4
Advertisement
Table of Contents
