Childproof Door Locks; Keyless Entry Key Pad Procedure; Message Center Procedure - Ford 2007 F-150 Owner's Manual

Ford 2007 automobile owner's manual
Hide thumbs Also See for 2007 F-150:
Table of Contents

Advertisement

horn will chirp once if autolock was deactivated or twice (one short
chirp and one long honk) if autolock was activated.
5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.
Note: After exiting the driver configuration mode, the horn will chirp
once to indicate a feature has been activated/deactivated.

Keyless entry key pad procedure

1. Turn the ignition to the 1 (OFF/LOCK) position.
2. Close all the doors.
3. Enter 5–digit entry code
4. Press and hold the 7 • 8. While holding the 7 • 8 press the 3 • 4.
5. Release the 3 • 4.
6. Release the 7 • 8.
The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.

Message center procedure

For information regarding the activation and deactivation of the
autolocks feature using the message center, refer to Message center (if
equipped) in the Driver Controls chapter.
CHILDPROOF DOOR LOCKS (ON VEHICLES WITH REAR DOORS)
• When these locks are set, the
rear doors cannot be opened from
the inside.
• The rear doors can be opened
from the outside when the doors
are unlocked.
The childproof locks are located on
rear edge of each rear door and
must be set separately for each
door. Setting the lock for one door
will not automatically set the lock for both doors.
• Move lock control up to engage the childproof lock.
• Move control down to disengage childproof locks.
2007 F-150 (f12)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
103

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents