AOpen AX4SPE Max Online Manual page 118
Hide thumbs
Also See for AX4SPE Max:
- Manual (59 pages) ,
- Easy installation manual (8 pages) ,
- Easy installation manual (8 pages)
Table of Contents
Advertisement
A
X
4
S
P
E
M
a
x
O
n
l
i
n
e
M
a
n
u
a
l
A
X
4
S
P
E
M
a
x
O
n
l
i
n
e
M
a
n
u
a
l
----------------------------------------------------------------------------------------------------
2) Adding the SiI RAID controller to an existing Windows NT 4.0 installation
----------------------------------------------------------------------------------------------------
Follow the instructions in this section to install the Silicon Image SiI 3112 driver on a system already running Windows NT 4.0.
1. Power off the system. Connect the hard drives to the SiI 3112 controller and insert the controller into a PCI slot. Power up the system.
2. After OS boots up, Click 'Start'
3. Under 'Settings', click 'Control Panel'.
4. Select 'SCSI Adapters' from the Control Panel.
5. Select the 'Drivers' tab and click 'Add'.
6. Click 'Have Disk'.
7. Insert the diskette labeled ' Silicon Image SiI 3112 SATA Raid Driver Installation Disk' into A: and press 'Enter'.
8. Choose 'Silicon Image SiI 3112 SATA Raid Controller' and click 'OK'.
9. See instructions in section 4 to verify controller was installed correctly.
------------------------------------------------------------------------------------------------------
3) Adding the SiI RAID controller to an existing Windows 2000/XP installation
------------------------------------------------------------------------------------------------------
Follow the instructions in this section to install the Silicon Image SiI 3112 driver on a system already running Windows 2000.
1. Power off the system. Connect the hard drives to the SiI 3112 controller and insert the controller into a PCI slot. Power up the system.
118
Advertisement
Table of Contents
