Octaire - AMX BCS Instruction Manual

Appendix A – Product Specific BCS Commands

Octaire

Octaire systems support the following items:
General Commands




Audio Commands (if system contains audio)
If the Octaire routes audio signals, it supports the following audio commands.





Specific Commands and Conditions


Diagnostic Commands
The Octaire displays system information in its splash screen for diagnostic purposes. The information
indicates the current status and well-being for some of the system components. For information on
system diagnostics that includes the commands and applies to all systems that support diagnostic
commands, see page 45.
Component Settings
The Octaire supports six component identity number settings (i0 through i4 and i7) in the following
table.
Component
All Components
Enclosure
Storage Blocks
Communication Interfaces
Hardware / Boards
System Sensors
Tip: The information in the table above is displayed when you enter ~scr! or ~scri0v0!
Auxiliary Commands
Auxiliary Commands Supported by Octaire
To cause a warm reboot
To view a splash screen with the lowest level of verbosity
32
Executing and disconnecting switches (see page 6 and page 7)
Verifying signal status (see page 8)
Defining and executing global presets (see page 11); this product supports 64 global presets
Error Code Reporting (see page 41)
Digital output volume control – absolute, relative, and increment/decrement methods
(see page 13)
Verifying volume status (see page 15)
Muting and un-muting outputs (see page 14)
Digital input gain control – absolute, relative, and increment/decrement methods (see page 16)
Verifying input gain status (see page 18)
When entering commands, use L0 (or omit level) for routing the All level (audio-follow-
video), L1 for routing the Video level, and L2 for routing the Audio level
Does not support local preset commands
Identity Number
i0
i1
i2
i3
i4
i7
~app!
~scr!
Instruction Manual – BCS Basic Control Structure Protocol