Power Up And Test - American Dynamics EDVR Quick Setup Manual

EDVR Quick Setup Guide
4 Connect one or more cameras to the Video In BNC connector(s).
Note
For video loop through, Touch Tracker (ADTT16E), and other connections, refer to the
Installation and Operation Guide that is included on the CD-ROM.
Video Loop
Through (BNC)
C. Power Up and Test
1 Attach the appropriate power cord to the Power Brick (external power supply) and connect to a
power source. Apply power to the EDVR system and to the connected video monitor and
camera(s).
Note
EDVR powers up automatically when connected to a power source.
2 If the unit does not power up automatically, insert a tool such as the tip of a ballpoint pen into
the front panel power/reset switch (near the lower right corner) and gently press. The unit will
start.
Note
The recessed power switch works in one of two ways: (1) Press quickly to turn the EDVR on or
off. (2) Press and hold for at least 3 seconds to restart the EDVR.
3 To set the Date and Time, press the MENU button. Select Quick Settings, press the ENTER
button. Use the shuttle ring to set date and time. Press the MENU button to Exit to the Main
Menu.
Note
Press the MENU button to set up the EDVR. For detailed set up instructions, refer to the
Installation and Operation Guide on the CD-ROM.
2
Video In (BNC)
Main Monitor Connector (BNC)
MENU button
ENTER button
Call Monitor Connector (BNC)
Network Connector
(Ethernet; RJ-45)
Jog Dial
Power/Reset Switch (recessed)
Power Connector
(12v)
Shuttle Ring
Hard Disk Busy Indicator
EDVR Quick Setup Guide