Photometric Chart; Troubleshooting - American DJ Inno Color Beam 12 User Instructions

Inno Color Beam 12
Inno Color Beam 12
American DJ Supply - www.americandj.com - Inno Color Beam 12 User Manual Page 17
© ®

Photometric Chart

UC3 Control
Inno Color Beam 12
Locate and remove the unit's power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry out
the fuse holder. Remove the bad fuse and replace with a new one. The
fuse holder has a built-in socket for a spare fuse be sure not to confuse
the spare fuse with active fuse.
Inno Color Beam 12
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
1. Use a soft cloth to wipe down the outside casing.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
Inno Color Beam 12
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is "hot"; on some other DMX devices
pin 2 may be 'hot'). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
If problems are not resolved; Contact American DJ® for service.
1-800-322-6337
American DJ Supply - www.americandj.com - Inno Color Beam 12 User Manual Page 18
© ®
Fuse Replacement
Cleaning

Troubleshooting