Getting Started; Turning Power On And Off; Initial System Start-Up; Opening And Closing The Movable Display - Alpine CDA-9851R Owner's Manual

Getting Started

SOURCE/
POWER RESET
g
MENU f
Connectable to Steering Remote Control Interface Box
You can operate this unit from the vehicle's control unit when
an Alpine Steering Remote Control Interface Box (optional) is
connected. For details, contact your Alpine dealer.

Turning Power On and Off

Press SOURCE/POWER to turn on the unit.
• The unit can be turned on by pressing any other button except eject
c.
Press and hold SOURCE/POWER for at least 2
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET with a ball-point pen or similar
pointed object.
6
-EN

Opening and Closing the Movable Display

Press c.
The movable display will open.
Rotary
encoder
To close the movable display, press c again.
The movable display will close.
• Do not apply shock to the movable display when it is open as it
• The display may be dim during low temperatures and immediately
c
• The display will stop at the set tilt angle when closing.

Display Tilt Adjustment

The movable display may be adjusted to 3 different tilt angles
depending upon user preference.
1
2
3
• The display will close a half minute after the ignition key is turned
• The adjusted tilt angle of the display is stored in memory. There is

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.
may result in malfunction of the unit.
after turning on the power. The brightness will return to normal as
time elapses.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Press MENU to select the TILT mode.
Turn the Rotary encoder to adjust the tilt angle of
the movable display.
Press and hold MENU for at least 2 seconds to
return to normal mode, or press MENU and select
RETURN to return to normal mode.
to the OFF position.
no need to re-adjust the tilt angle when the power is turned back on.
Caution
Keep hands (or any other object) away from the display while it is
opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
Movable display