Installation - Alpine CDA-9851R Owner's Manual

Installation

Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit and
may cause a fire.
Air ventilation hole
1
Bracket
Dashboard
Mounting sleeve
(Included)
Slide mounting sleeve from main unit (see
"Removal" on this page). Slide the mounting sleeve
into the dashboard and fix it with the metal
shackles.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the CDA-9851R and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Connect all the leads of the CDA-9851R
according to details described in the CONNECTION
section.
Metal plate
Detachable
Front panel
Rubber Cap
(Included)
Hex Bolt
(Included)
this unit
Screw
Bolt Stud
∗
this unit
• For the screw *, provide a proper screw to the chassis installing
location.
3
Slide the CDA-9851R into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard. Install the Detachable Front Panel.
Removal
1 Remove the detachable front panel.
2 Insert the optional brackets into the back, along the
guides on either side of the unit. The unit can now be
removed from the mounting sleeve.
this unit
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
this unit
Mounting Bracket
Bracket
(Included)
Front frame
Screws (M5 × 8)
(Included)
27
-EN