Using The Call Forward Feature; Call Forward Unconditional - Allied Telesis AT-VP504E FXS User Manual

Chapter 1 - Using the AT-VP504E FXS
Using the Call For-
ward Feature
Call Forward
Unconditional
AT-VP504E FXS
If you want to get back to the first call (the call on hold), you
5.
must perform two Flash Hooks.
You are back with the first call and the third party is released.
There are three types of Call Forward.
The Call Forward – Unconditional
calls to another extension or line.
When forwarding your calls outside the system, a brief ring will be
heard on your phone to remind you that a call forward has been
established. You can still make calls from your phone.
To forward calls:
Take the receiver off-hook.
1.
Wait for the dial tone.
2.
Dial *25.
3.
Note: The "*25" sequence can be user-configured. Check with your
system administrator for the exact sequence actually implemented.
Wait for the transfer tone (three "beeps") followed by the dial
4.
tone.
Dial the number to which you want to forward your calls.
5.
Dial any access code if required.
Wait for three "beeps" followed by a silent pause.
6.
The call forward is established.
Hang up your phone.
7.
The calls are checked against the dial maps set up by your
system administrator. See your system administrator for
more information.
6. Only valid for units that run the SIP signalling protocol.
User's Manual (SIP/MGCP Version)
6
feature allows you to forward your
11