Advertisement
3. Secure the AP with one of the included screws.
F
IGURE
Use either the cross-head or hex-head screw. The hex-head screw requires a
less commonly available tool and may increase casual security. Install the
screw through the mounting hole in the front of the AP chassis (previously
covered by the LED label) and into the cradle mounting pin. Do not overtighten.
4. Apply the new LED label.
5. Secure the AP , if desired.
To prevent the unauthorized removal of the AP from its installed location, use a
Kensington MicroSaver Security Cable (not included). Wrap the security cable
around an immovable object, insert the cable's lock into the Kensington
Security Slot on the back of the AP , and turn the key.
6. Orient the antennas.
For best performance, orient the antennas vertically.
7. Resume standard installation.
Once mounting is complete, connect the required cables and complete the
installation as described in the AP60/61 Wireless Access Point Installation
Guide.
9 Installing the Cradle Screw
The AP60/61 Mounting Kit Installation Notes
9
Advertisement
