Page 1
Access Point Enclosure Installation Instructions The enclosure for the OmniAccess AP60, and AP61 Access Point (OAW-AP60-ENCL) is an enclosure designed to provide protection for APs when deployed in environments not suitable for electronics components (dirt, moisture, etc). The enclosure does NOT protect the AP against extreme high or low temperatures and is not waterproof.
OmniAccess AP60 Enclosure Installation Notes: Installation Guide Packing List The OAW-AP60-ENCL includes: Enclosure Housing base and top (11.75” (29.85cm) wide x 9” (22.86cm) deep x 3.5” (8.89cm) high) Enclosure screws (6) Ventilation cap, template, and screws (3) Cable seal Mounting plate (for the AP 60/61) Mounting plate screws (2)—typically packed with cable seal...
Page 3
Recommended tools —Be sure to follow all tool safety instructions. AUTION Phillips head (#2) screw driver Sharp knife Drill and bits for plastic - various sizes (depends on components supplied) Cable tools for attaching cable connector Preparing the Enclosure To determine the best location for the cable seal and ventilation cap, lay out the mounting plate with an AP aligned to the mounting plate tabs.
Page 4
OmniAccess AP60 Enclosure Installation Notes: Installation Guide Locate the cable seal on the bottom or side allowing for as direct a cable path inside the enclosure as possible while preventing moisture from entering the enclosure housing. (Here the cable seal is centered on the bottom of the enclosure.)