To Replace The Chassis Fan Filter - Alcatel-Lucent 1200 User Manual

To Replace the Chassis Fan Filter

.........................................................................................................................................................................................
When to use
As needed, periodically clean or replace the chassis fan filter using the following
procedure. Refer to
procedure.
This procedure must also be followed to remove the chassis fan filter cover and filter
before performing a hot swap of a fan unit (refer to the procedure
of a Fan Unit" (p.
Task: replacing the chassis fan filter
Complete the following steps to replace the chassis fan filter:
.........................................................................................................................................................................
At the front of the Brick device, unscrew the thumbscrews over the tabs of the chassis fan
1
filter cover, pull the filter cover down and slightly forward, and remove it.
.........................................................................................................................................................................
Remove the fan filter and clean or discard it.
2
.........................................................................................................................................................................
Replace the cleaned (or new) filter .
3
...................................................................
32
Figure 10, "Fan Filter Replacement" (p. 33)
34)).
while performing this
"To Perform a Hot Swap