To Change The Sfp Module For A Model 1200 Brick Device Gigabit Only Port - Alcatel-Lucent 1200 User Manual

To Change the SFP Module for a Model 1200 Brick Device
Gigabit Only Port
.........................................................................................................................................................................................
When to use
Use the following tasks to install an SFP module or to remove an SFP module for a
Gigabit only port on a Model 1200 Brick device.
Important! There are a variety of SFP modules that are commercially available.
However, Alcatel-Lucent only qualifies that the SFP modules that can be ordered from
Alcatel-Lucent will work properly. The user assumes all liability when using SFP
modules other than those available from Alcatel-Lucent. Contact your sales
representative for additional information.
Task: installing an SFP module
Complete the following steps to install an SFP module:
.........................................................................................................................................................................
Remove the SFP module from its protective packaging, and verify that the SFP module is
1
the correct model for your network configuration.
Note: you can identify SFP modules by the SFP module label, which also lists the SFP
model number and wavelength (if fiber).
Refer to
locate the SFP module label.
...................................................................
12
Figure 2, "SFP Module (Top, Bottom, Side, and Front Views)" (p. 13) to