To Install A Model 1200 Brick Device - Alcatel-Lucent 1200 User Manual

To Install a Model 1200 Brick Device

.........................................................................................................................................................................................
When to use
Use this procedure to install a 1200 Brick device. It includes special handling instructions
for the AC and DC versions of the Model 1200 Brick device.
Task: installing a Model 1200 Brick device
Complete the following steps to install a Model 1200 Brick device.
.........................................................................................................................................................................
Remove the Brick device from the carton in which it was shipped.
1
.........................................................................................................................................................................
If additional support is needed (other than the two front brackets), use the additional side
2
mounted brackets. Slide the two adjustable rear mounting brackets into the mounting guide.
Depending on the rack mounting requirements, the rear brackets can be inserted in the
guide in either position shown in
The General Devices slide rails (part number C300-S-122) can be used for cabinet
mounting applications.
.........................................................................................................................................................................
Position the Brick device in the rack and fasten the Brick device to the rack using the front
3
brackets on either side of the device with two #2 Phillips head screws per bracket. If the
Figure 1, " Rack Mounting Brackets" (p.
...................................................................
10).
9