Onkyo HTP-348 Instruction Manual

5.1ch Home Cinema Package
Front speaker (SKF-548)
(White)
(Red)
Front speakers
Speaker cables 3.5 m
(11 ft.)
* Configuration of the rubber stoppers may be different from the figure, such as being
2 sheets instead of 1 sheet, but the total number will be same.
Keyhole slot
Speaker terminals
SKF-548
SKR-548
Wall Mounting
To mount the front/surround speakers vertically, use the
keyhole slot shown to hang each speaker on a screw that's
securely screwed into the wall.
Keyhole slot for
wall mounting
Thick rubber
stoppers
Using the Rubber Stoppers for a More Stable Platform
We recommend using the supplied rubber stoppers to
achieve the best possible sound from your speakers. The
rubber stoppers prevent the speakers from moving, provid-
ing a more stable platform. Use thick stoppers for the cen-
ter speaker, and thin stoppers for the other speakers.
Enjoying Home Cinema
The Home Cinema means that you can enjoy surround sound with a real sense of movement in your own home — just like being in
a movie theater or concert hall.
Front left and right speakers (SKF-548)
They should be positioned facing the listener at about ear level,
and equally spaced from the TV. Angle them inward slightly so as
to create a triangle, with the listener at the apex.
Center speaker (SKC-548)
Position it close to your TV (preferably
on top) facing forward at about ear
level, or at the same height as the
front left and right speakers.
Subwoofer (SKW-348)
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects) chan-
nel and bass from the satellite speakers when a crossover is specified. The volume
and quality of the bass output from your subwoofer will depend on its position, the
shape of your listening room, and your listening position. In general, a good bass
sound can be obtained by installing the subwoofer in a front corner, or at one-third
the way along the front wall, as shown.

Connecting the Speakers

Front right
speaker
Red
Purple
Subwoofer
Surround right
speaker
HTP-348
E
n
Center speaker (SKC-548)
Speaker cable 3.0 m
Center speaker
12 thick rubber stoppers
Speaker terminals
SKC-548
Keyhole slots
To mount the center speaker horizontally, use the two key-
hole slots shown to hang the speaker on two screws that are
securely screwed into the wall.
Keyhole slots for wall mounting
Thick rubber
stoppers
183 mm (7-3/16")
Thin rubber stoppers
Bottom of the
SKF-548
Surround left and right speakers (SKR-548)
Position them at the sides of the listener, or
slightly behind, about 60 to 100 cm (2 to 3 feet)
above ear level. Ideally they should be equally
spaced from the listener.
1/3 of wall position
Front left
speaker
Center speaker
Green
White
Speaker Connection
Precautions
Read the following before connecting your
speakers:
• Turn off your receiver before making any
connections.
Blue
• Pay close attention to speaker
Gray wiring polarity. Connect posi-
tive (+) terminals to only pos-
itive (+) terminals, and
negative (–) terminals to only negative (–)
terminals. If the speakers are wired incor-
Surround left
rectly, the sound will be out of phase and
speaker
will sound unnatural.
• Be careful not to short the positive and
negative wires. Doing so may damage
your amp.
Surround speaker (SKR-548)
(Green)
Surround speakers
(10 ft.)
* 16 thin rubber stoppers
Caution
• The front grilles are not designed to be removed so do not
attempt to remove them forcibly, as this will damage
them.
Caution
• A mounting screw's ability to support a
speaker depends on how well it's
anchored to the wall. If you have hol-
low walls, screw each mounting screw
into a stud. If there are no studs, or the
walls are solid, use suitable wall
anchors. Use screws with a head diame-
ter of 9 mm (5/16") or less and a shank diameter of 4 mm
(1/8") or less. With hollow walls, use a cable/pipe detec-
tor to check for any power cables or water pipes before
making any holes.
• Leave a gap of between 5 mm (3/16") and 10 mm
(7/16") between the wall and the base of the screw head,
as shown. (We recommend that you consult a home instal-
lation professional.)
Bottom of the
SKR-548
Bottom of the
SKC-548

Specifications

■
Passive Subwoofer (SKW-348)
Type
Impedance
Maximum input power
Sensitivity
Frequency response
Cabinet capacity
Dimensions (W × H × D)
Weight
Drivers unit
Terminal
Other
■
Front Speakers (SKF-548)
Type
Impedance
Maximum input power
Sensitivity
Frequency response
Cabinet capacity
Corner
Dimensions (W × H × D)
position
Weight
Drivers unit
Terminal
Keyhole slot
Grille
Other
Note
For non-magnetic shielded speakers:
Try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to 30
minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field,
thereby removing any discoloration effects.
SN 29400630
(C) Copyright 2010 ONKYO SOUND & VISION CORPORATION Japan. All rights reserved.
Subwoofer (SKW-348)
(Blue) (Gray)
Speaker cables 8.0 m
Subwoofer
(26 ft.)
*
Using the Floor Pads for Subwoofer
If the subwoofer is placed on a hard
floor (wood, vinyl, tile, etc.) and
playback is very loud, the sub-
Wall
woofer's feet may damage the
flooring. To prevent this, place the
supplied pads underneath the sub-
woofer's feet. The pads also pro-
5 to 10 mm
vide a stable base for the subwoofer.
(3/16" to 7/16")
Thick rubber stoppers
50 mm
(1-15/16")
12 mm (1/2")
■
Center Speaker (SKC-548)
Bass-reflex type Passive subwoofer Type
6 Ω
Impedance
130 W Maximum input power
82 dB/W/m Sensitivity
30 Hz to 150 Hz Frequency response
24 L Cabinet capacity
211 mm × 425 mm × 381 mm Dimensions (W × H × D)
(incl. projection)
5.5 kg Weight
16 cm Cone × 1
Drivers unit
Spring type color coded Terminal
Non-magnetic shielding Keyhole slot
Grille
Other
■
Full Range Bass-reflex Surround Speakers (SKR-548)
6 Ω
120 W Type
82 dB/W/m Impedance
80 Hz to 20 kHz Maximum input power
1.0 L Sensitivity
101 mm × 161 mm × 115 mm Frequency response
(incl. grille and projection)
Cabinet capacity
0.8 kg Dimensions (W × H × D)
8 cm Cone × 1
Spring type color coded Weight
Available Drivers unit
Fixed Terminal
Magnetic shielding Keyhole slot
Grille
Other
Specifications and appearance are subject to change without
prior notice.
(Purple)
4 floor pads*
Speaker cable 3.0 m
(10 ft.)
Speaker terminals
Pad
Full Range Bass-reflex
6 Ω
120 W
82 dB/W/m
80 Hz to 20 kHz
1.4 L
230 mm × 103 mm × 115 mm
(incl. grille and projection)
0.9 kg
8 cm Cone × 1
Spring type color coded
Available
Fixed
Magnetic shielding
Full Range Bass-reflex
6 Ω
120 W
80 dB/W/m
80 Hz to 20 kHz
1.0 L
101 mm × 161 mm × 115 mm
(incl. grille and projection)
0.7 kg
8 cm Cone × 1
Spring type color coded
Available
Fixed
Non-magnetic shielding
Y1101-1
* 2 9 4 0 0 6 3 0 *