Setting The Clock; Setting Accuclock To Use A Specific Station - Onkyo BR-925UKD Instruction Manual

Setting the Clock

Setting AccuClock to Use a Specific Station

The AccuClock function normally uses the FM station with the strongest signal to set the clock. However, if the clock
cannot be set properly using that station, you can specify which FM station the AccuClock function should use. This
must be an FM station that supports RDS CT (Clock Time) information.
1 Press the [TIMER] button.
Remote
controller
2
Press [ENTER] with "Clock"
selected.
Clock
Timer 1
Timer 2
3 Use the Up and Down [ ]/[ ] but-
tons to select "AccuClock", and
then press [ENTER].
4 Press [ENTER].
The frequency flashes on the display.
C l ock
RDS-CT Station
The asterisks indicate that the
AccuClock function is on.
5
Use the Fast Reverse and Fast For-
ward [
into the FM station.
Tip:
If you press the [ENTER] button instead of
using the Fast Reverse and Fast Forward
[ ]/[ ] buttons, the CD/HDD
receiver will automatically search for a
suitable station.
The RDS indicator appears when tuned
into a station that supports RDS.
The RDS indicator will flash while the
CD/HDD receiver searches for a station
and light up continuously when a station
is found.
: FM 87.50MHz
]/[ ] buttons to tune
6
When you've selected the station,
press [ENTER].
While the clock is being set, "Wait..."
flashes on the display. It may take a few
minutes to set the clock. When the clock
has been set, the message "Clock
Adjusted" scrolls across the display, then
the day and time are displayed for a
while.
Notes:
• If the clock is not set correctly, specify
another FM station and try again or set
the clock manually (see page 66).
• The AccuClock function automatically
updates the clock every day. If you don't
want it to, you can turn off the Accu-
Clock function (see page 23).
65