Speaker Level Calibration - Onkyo TX-SR653E Instruction Manual

First Time Setup—Continued

Speaker Level Calibration

This setting is set automatically by the Automatic
Speaker Setup function (see page 38).
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
Note:
The speakers cannot be calibrated while the output of the
AV receiver is muted, while a pair of headphones is con-
nected, or when using the multichannel input.
CD TAPE
7 8
+ 10
0
10 11
--/---
INPUT SELECTOR
MACRO
1 2
REMOTE MODE
1
RECEIVER DVD
TAPE/AMP
TV VCR
DIMMER
2
+
CH
DISC ENTER
ALBUM
-
PREV
CH
DISPLAY
REC PLAYLIST
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
RECEIVER
The main menu appears onscreen.
TUNER
9
T V VOL
CLEAR
12
3 ZONE2
CD HDD
CABLE SAT
CDR MD
SLEEP
2, 3
VOL
1, 5
MUTING
RANDOM
2
Use the Up and Down [
buttons to select "3. Level Cali-
bration," and then press
ENTER
[ENTER].
The Level Calibration menu appears
and the pink noise test tone is output by
the front left speaker.
ENTER
Note:
Speakers that you set to No or None on
the Speaker Configuration page
(page 45) cannot be selected.
3
Use the Up and Down [
buttons to select each speaker,
and use the Left and Right [
ENTER
[ ] buttons to set the volume.
The volume can be adjusted from –12
to +12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
4
Repeat step 3 until the volume of
the test tone from each speaker
is the same.
5
Press the [SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed by using the
remote controller. First press the [TEST TONE] button
to output the test tone. Use the [LEVEL–] and
[LEVEL+] buttons to set the volume, and use the [CH
SEL] button to select the speakers.
]/[ ]
]/[ ]
]/
49