The Transmitter - Omega RS-310 Operation Manual

The Valet Switch
One of the components, mounted in the vehicle's interior, is the Valet
Switch which is used for a variety of functions including transmitter and
feature programming.
The Valet Switch has three main functions:
• The Valet Switch can be used to turn off the
remote engine starting functions of the system
placing it in "Remote Start Valet Mode".
• The Valet Switch can also be used, in conjunction with the vehicle's
ignition key, to perform an emergency override when the system is in a
"locked" state. This is used in the event the transmitter is lost or becomes
inoperable. This is referred to as "performing an Emergency Override".
• The Valet Switch is used in the procedure of programming operational
features and also for encoding transmitters to the system.
A complete description of the Valet Switch and its operations is on pages
19-20.
The
"lock"
button
" " button
trunk
Transmitter part number: 146-07B
"lock"
• Pressing and releasing the "lock" button locks the doors.
• Pressing and holding this button for three seconds will first lock, then
activate the Panic feature.
Transmitter
"unlock"
button
" " button
start
Transmitter battery replacement:
Remove the small screw from the
lower back case, and separate the
transmitter case halves. Replace the
CR2032 (or 2 CR2016 batteries) coin-
type battery and reassemble the transmitter.
Page - 4
This feature changes the operation of the Green wire (negative) on the satellite relay
port. This gives you the flexibility to accomodate certain vehicles that require any
out-of-the-ordinary pulses or remote start timing.
• The first setting operates as a secondary START output. This will have the same
pulse timing as the large Violet wire on the main harness.
• The second setting will give a 0.8 second pulse immediately after the large
Violet wire's output stops.
• The third setting will give a 0.8 second pulse immediately after the remote start
shuts down by any means.
• The fourth setting operates as a secondary ACCESSORY output. This will have
the same operation as the large Orange wire on the main harness. This fea-
ture should only be programmed by the installer.
Feature #4 Extended Starter Cranking Time
Factory Default Setting Minimum (.7 Second)
( press "lock" button to program
Options:
press "unlock" button to program
Medium Lo (1.25 Second) (
Medium Hi (1.75 Second) ( press "trunk" button to program
press "start" button to program
Maximum (2.5 Second) (
Extended Starter Cranking Time operates in conjunction with the feature #1's
"Tachless" setting. When the system is set for "Tachless", this feature sets the
duration of the starter output's for the 1st start attempt. If the engine doesn't start
on the first attempt, the system will retry up to 3 more times. With each attempt, the
output will be extended by 0.2 seconds. There are four different base starter output
settings. While the default-set minimum is sufficient for most vehicles; the
Extended Starter Cranking Time can be used for difficult-to-start engines. This
feature should only be programmed by the installer.
Feature #5 Doorlocking Functions
Factory Default Setting 0.8 Second Lock & Unlock Output
( press "lock" button to program
Options:
3 Second Lock & Unlock Output
Double Pulse Unlock Output
Total Closure Lock Output
This single feature gives the installer several needed options, to match the RS-310's
doorlocking outputs to suite different vehicle requirements.
• The first setting (programmed by the "arm/lock" button) has the system
produce both the lock and unlock outputs as 0.8 second in duration. This is the
most common form of output needed, which interfaces most vehicles.
)
)
)
)
)
( press "unlock" button to program
( press "trunk" button to program
press "start" button to program
(
Page - 17
)
)
)