Dial And Hold Procedures - HP 4935A Operating And Service Manual

DIAL AND HOLD PROCEDURES

is as follows:
1. Connect circuit to left 310 jack.
2.
Push NOR switch to connect TRMT side to left jack.
3.
4 . Push TRMT DIAL switch. Use the butt-in to dial the remote end of the circuit.
5.
6 . Push the TRMT DIAL switch again to release it. This disengages the dial circuitry and allows
connect RCV side to left 310 jack.
For 2 two-wire circuits, follow preceding steps 1 through 6 for the first side, then:
1 .
Push RCV HOLD switch.
2. Push REV switch to transfer the transmit side.
3. Push TRMT DIAL switch. Use the butt-in to dial-up the other end.
4 .
After the circuit is answered, push the TRMT HOLD switch to hold this circuit.
5 .
Release TRMT DIAL switch by pushing it again.
Figure 3-2. Measurements (Continued)
Model 4935A