Instrument Options - Agilent Technologies 8495 Operating And Service Manual

1 Introduction
C A U T I O N

Instrument Options

14
Do not exceed the RF power rating of 1 W average or 100 W peak with a
maximum pulse width of 10 μs. Do not connect an attenuator RF input or
output connector to greater than ±7 Vdc. If the attenuator must be connected
to a device with a potential greater than ±7 Vdc, use a blocking capacitor.
Each instrument is specified with an option number which denotes
the configuration of the input and output connectors.
Table 4

Instrument Options

Option
001
002
[1]
003
[2]
024
011
016
[2]
060
[1] Option 003 is not available on the 8495G.
[2] Option 024 and 060 are default options unless specified otherwise.
Agilent 8494/95/96G/H Attenuators Operating and Service Manual
Description
Type-N (f) connectors
SMA female connectors
APC-7 connectors
24 Vdc supply voltage
5 V operation instead of standard 24 V
14-pin dip plug, 16-inch DC ribbon cable
Viking to bare wire cable