Table of Contents
Advertisement
Crimp-and-Insert
The following accessories are necessary for use with crimp-and-insert
Terminal Module
Option A3E:
Accessories
Single-Conductor and
A crimp-and-insert contact is crimped onto one end of a wire. The other
end is not terminated. Order Agilent 91510A.
Contact
A crimp-and-insert contact is crimped onto each conductor at one end of a
Shielded-Twisted-Pair and
shielded-twisted-pair cable. The other end is not terminated. Order
Contacts
Agilent 91511A.
A crimp-and-insert contact is crimped onto each end of a single-conductor
Jumper Wire and Contacts
jumper wire. This jumper is typically used to tie two pins together in a
single crimp-and-insert connector. Order Agilent 91512A.
These contacts may be crimped onto a conductor and then inserted into a
Crimp-and-Insert Contacts
crimp-and-insert connector. The crimp tool kit is required to crimp the
contacts onto a conductor and remove the contact from the connector.
Order Agilent 91515A.
Crimp-and-Insert Tools
The hand crimp tool (part number Agilent 91518A) is used for crimping
contacts onto a conductor. The pin extractor tool (part number
Agilent 91519A) is required for removing contacts from the
crimp-and-insert connector. These products are not included with
Option A3E or with the terminal option accessories listed earlier.
28
Module Setup and Installation
Chapter 1
Advertisement
Table of Contents
