3. Insert the MMC card (6) in the slot with the contact surface towards
the top of the main unit (where the buttons are). Lock the card in by
pushing it in. To release the card, push it slightly in again.
4. Check that the NTSC/PAL switch (5) is in the correct position, make
sure that the RCA cable is in the provided notch (7) and close the main
unit.
5. Install the provided remote control CR2032 button battery (8).
If you are using the remote control, it must be within a maximum of 7
meters of the main unit, and there must be no obstructions between
the IR ports of the main unit and the remote control.
6. Connect the lead from the
charger to the socket at the back
of the Nokia Image Viewer (9)
and connect the charger to an AC
wall socket. When connected to a
charger, the Nokia Image Viewer
does not use or recharge the
batteries.
G e t t i n g s t a r t e d
7