Installation - Niles VCS-2D Installation & Operation Manual

P P
R R E E M M I I U U M M

Installation

If you are installing the VCS-2D into an existing wall, take
time to consider any possible obstructions which may be
hidden inside the wall, such as wood and metal studs; elec-
trical, telephone or other types of wiring; plumbing; con-
duit; old wall safes; etc.
1. Install the electrical box or p-ring in the usual manner.
2. Run all the necessary wiring to the VCS-2D. Label the
wires for future reference.
3. Make the connections to the VCS-2D. Locate the con-
nectors for the VCS-2D (remove them if they are plugged
in). Next, strip " of insulation from the end of each wire.
1/4
Tightly twist the end of each wire until there are no frayed
ends. Insert each wire into the appropriate hole on the
removable connector blocks; secure the wiring to the con-
nectors by tightening the small connector screws. Be cer-
tain that proper phasing is observed—connect the positive
terminals on the VCS-2D to the positive terminals on the
amplifier and speakers; the negative terminals on the VCS-
2D to the negative terminals on the amplifier and speakers.
See (Figures 3 and 4).
4. Plug the connectors into the VCS-2D as shown in (Figure 5)
on next page.
The inputs of the VCS-2D are the connector pins
labeled "AMPLIFIER" . The outputs are the connector
pins labeled "SPEAKERS" . Be sure not to reverse these
connections or the VCS-2D will not function properly.
S S V V
T T E E R R E E O O O O L L U U M M E E
C C
O O N N T T R R O O L L
Figure 3
Wiring the Connectors
Receiver
To
Amplifier (Input)
To
Speakers (Output)
Speakers
Figure 4
Wiring Diagram
VCS-2D
8