After Changing The Jets - Miele KM 370 G Installation Instructions Manual

Conversion to another type of gas

After changing the jets

^ Assemble the removed burner parts
in reverse order and check for leaks
by operating the burner without the
upper section of the hob in place
(use a match to ignite the flame).
^ Remove the burner parts again.
^ Then replace the upper section of the
hob.
24
^ Screw in the burner bases and
re-assemble the burner parts, making
sure they are in the correct order.
^ Replace the controls.
^ Finally ignite all the burners to check
that they are operating correctly.
The flame must not go out in the lowest
setting, or when the control is turned
quickly from a high to a low setting.
In the highest setting the flame must
have a distinctive and visible core.
Stick the label supplied with the jets
above the label stating the type of
gas being used.