Miele KTN 12720 SD Operating And Installation Manual page 41

^ Fit hinge pin c from below into the
bottom door.
^ Slowly close the bottom door. As you
do so hinge pin c will slide into the
guides on the side of door bearing
b.
^ Secure hinge pin c by fitting screw
a into the door bearing.
Changing the door hinging
Refitting the handle:
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws b.
Mounting plate c must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^ tighten both grub screws a with an
allen key until mounting plate c lines
up correctly.
^ Then tighten all 4 fixing screws b.
^ Slide the side section of the handle
d into the guides on the mounting
plate until it clicks into place.
41