Miele KTN 12720 SD Operating And Installation Manual page 40

Changing the door hinging
^ Unscrew door bearing b and screw
it into position on the opposite side.
See diagram on previous page.
^ Remove cover d and refit on the
opposite side.
^ With the upper door closed, pull
hinge pin e downwards to remove it.
^ Open the upper door carefully, and
pull it downwards and off.
^ Take care not to lose the washers.
^ Remove cover f, and unscrew hinge
bracket g.
^ Remove cover i and undo bracket
h. Turn cover i and bracket h
through 180° and refit on the
opposite side.
^ Screw hinge bracket g into the
opposite side.
^ Unscrew hinge pin j and fit it into
the neighbouring hole in the hinge
bracket.
40
^ Turn cover f through 180°, and fit it
on the other side.
^ Remove cover caps k, and unscrew
hinge bracket l.
^ Turn hinge bracket l through 180°
and screw into position on the
opposite side.
^ Refit cover caps k on the opposite
side.
^ Remove the plugs from the door
bearing bushes in the top of the
doors and refit on the opposite side.
^ Hang the upper door on hinge pin j
and then close the appliance door.
^ Push hinge pin e with the longer
section at the top from below into
hinge bracket l in the upper door.
^ Hang the bottom appliance door on
hinge pin e.