Check And Fault Messages - Miele T 8402 C Operating Instructions Manual

Problem solving guide

Check and fault messages

Problem
The Empty container
indicator light comes
on.
The programme stops
and the Machine iron
or Hand iron indicator
light flashes.
The buzzer sounds.
The Finish/
Anti-crease indicator
light flashes while
drying is in progress.
The programme stops
and the Finish/
Anti-crease indicator
light comes on.
The buzzer sounds.
The Cooling down
indicator light comes
on. The buzzer
sounds.
30
Possible cause
The condensed water
container is full or there is
kink in the drain hose.
No obvious cause.
The programme selector
was moved after the start of
a programme. The
programme continues to
run as normal.
This is not a fault.
The electronic unit has
recognised that there is not
enough laundry in the drum
and cancelled the
programme.
Drying items which are
already dry can also cause
the programme to be
cancelled.
The dryer is not working
efficiently or economically.
Remedy
– Empty the condensed
water container.
– Check the drain hose.
– The indicator light will
go out if you open and
close the door.
– Switch the dryer off and
then on again.
– Then start the
programme again.
If the programme stops
again and the indicator
light flashes again there is
a fault. Contact the Miele
Service Department.
Turn the selector back to
the original position and
the indicator light will go
out.
Use the Warm air
programme (timed drying)
to dry individual items.
Before changing a
programme: Open and
close the door.
See the previous page
under "Drying is taking
too long ...".