Before The End Of A Programme; At The End Of A Programme; Remove The Laundry - Miele T 4882 C Operating Instructions Manual

There is a cooling down phase at the
end of the drying sequence: Cooling
down will appear in the display. The
programme will not finish until the
cooling down phase has been
completed.
There is no cooling down phase at the
end of the following programmes:
Woollens handcare, Smoothing.
Anti-crease and Finish will appear in
the display to indicate that the
programme has finished. The buzzer
will sound.
During the Anti-crease phase (factory
default setting) the drum will continue to
rotate at intervals to prevent laundry
creasing if you do not wish to remove it
immediately. The anti-crease phase
lasts for 1 hour.
F
^ Press the a button to open the door.

^ Remove the laundry.

Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
If the appliance is switched on at the
mains and the door is opened, the
drum lighting will come on. It will go out
a few minutes later to save energy.
^ Press the s button to switch the
dryer off.
^ Clean the fluff filters.
^ Close the door.
16
^ Empty the condensed water
container (unless the dryer is
connected for external drainage).