Starting A Programme; After Drying; Additional Notes - Miele T 260 Operating Instructions Manual

F
^ Press the START button.
The drying cycle begins. The drying
stage reached is shown by the se-
quence indicator lights on the right
hand side of the control panel.
At the end of the drying phase a cool-
ing down phase commences to cool
the laundry down.
G
When the drying programme has fin-
ished the Anti-crease / finish sequence
indicator light comes on.
A 0 then appears in the display. The
laundry can now be removed. If the
Anti-crease option has been selected
(see "Programmable Functions") the
drum will continue to rotate at intervals
to prevent the laundry creasing. The
anti-crease light remains lit, but you can
remove the laundry at any time.
^ Press the Door button to open the
door.
^ Remove the laundry.
Make sure that the drum is empty. If
items are left in the dryer, they could
be damaged by overdrying when
the dryer is next used.
^ After every cycle remove the fluff
from the fluff filter in the door (see
"Cleaning and Care").
^ Close the door and switch the ma-
chine off using the l-On/0-Off button.
Clean out airways
This indicator light comes on to warn
you that the dryer is not working effi-
ciently. This may be because:
– the fluff filter in the door is blocked;
– the vent ducting or the ventilation
outlet is blocked;
– the vent ducting is very long
(see "Installation - venting" for notes
on duct length and diameter).
If it is not possible to shorten the vent
ducting, the Clean out airways indi-
cator light will remind you after each
drying cycle that the fluff filter needs
to be cleaned.
17