Miele DG 4064 Operating Instructions Manual page 8

Warning and Safety instructions
Safety with children
The appliance must be installed at
such a height that small children cannot
reach the appliance door, which gets
hot during use.
Use the system lock to ensure that
children cannot switch the appliance on
by mistake.
The appliance is only intended for
use by adults who have read these
instructions.
It is not a toy! Children may not fully
understand the potential dangers of
using it. To avoid the risk of injury, keep
children away from the steam oven at
all times, do not allow them to play with
it or to play with the controls. They
should be supervised whenever you
are working in the kitchen.
The appliance gets hot when in use
and remains hot for quite a while after
being switched off. To safeguard
against burning, keep children well
away from the appliance at all times.
Warning: Take care in the area
around the door hinges. Danger of
injury. Keep children well away.
Packaging, e.g. cling film,
polystyrene and plastic wrappings,
must be kept out of the reach of babies
and young children. Danger of
suffocation. Dispose of or recycle all
packaging safely as soon as possible.
8
Technical safety
Before installation, check the
appliance for visible signs of damage.
Do not use a damaged appliance. It
could be dangerous.
Before installation, check the water
hoses for visible signs of damage.
The stopcock for the water inlet
must be located so that it is easily
accessible after the appliance has
been built in.
The appliance must be installed and
connected to all services by a suitably
qualified and competent person in strict
accordance with current local and
national electrical and plumbing safety
regulations. The manufacturer cannot
be held liable for damage caused by
incorrect installation or connection.
The electrical safety of this
appliance can only be guaranteed
when continuity is complete between it
and an effective earthing system which
complies with current local and national
safety regulations. It is most important
that this basic safety requirement is
present and regularly tested, and
where there is any doubt, the on-site
wiring system should be inspected by a
qualified electrician. Miele cannot be
held liable for the consequences of an
inadequate earthing system (e.g.
electric shock).