Fitting The Matching Door Front - Miele G 673 Operating Instructions Manual

Installation
3. Fitting the matching door
front
The front of the dishwasher needs to
be fitted with a base unit front to match
the kitchen furniture. This door front
may be a single panel or a two-piece
panel, divided to give a dummy drawer
facia line.
Dimensions:
Width:
Depending on the width of your dish-
washer, a base unit front of either 45
cm or 60 cm width;
Total height:
height of a full base unit front, or with a
two-piece panel, height of shorter unit
front plus gap plus dummy drawer
facia;
Thickness:
at least 18 mm thickness in the areas
where the fixing bracket is screwed on.
66
A door handle must be fitted to the
front of the door front before the fixing
bracket is fitted.
The door handle fixing screws must
be countersunk, to avoid any protru-
sions at the rear of the door front.
Position the door handle to match the
others on the kitchen furniture. It should
be at drawer height in the centre of the
panel.