Connection To The Water Inlet - Miele G 670 Operating Instructions Manual

Plumbing
Plumbing

Connection to the water inlet

Water in the dishwasher must not
be used as drinking water.
The dishwasher may be connected
to a cold or hot water supply, max.
60 °C.
Connection to a hot water supply
would save time.
When connected to a hot water supply
all programme stages which would
otherwise be carried out with cold
water (pre-wash and interim rinse)
as well as the COLD PRE-WASH will
be carried out with hot water.
The inlet hose is approx. 1.5 m long;
a longer hose (4 m) may be bought
from the Miele Spare Parts Depart-
ment.
A stopcock with a 3/4" male thread
must be provided on site.
The dishwasher is constructed to
comply with Australian standard
regulations, and may be connected
to a suitable supply without an extra
non-return valve provided that na-
tional regulations allow this.
The water pressure (flow rate at the
take-off point) must be acc. to speci-
fiation (see "Technical Data").
If the water pressure is too low the
water intake time must be increased
(see chapter "Checking the water
level").
If the water pressure is too high, a
pressure reducer valve must be fitted.
64
The water inlet hose must not be
shortened or damaged in any way
(see illustration).
Connect the inlet hose with the "Water-
proof-System" preferably vertically
(use an angle connector if necessary).
If this is not possible, it can be in-
stalled horizontally, but it is essen-
tial that the main body of the "Water-
proof valve" box is above the hose
exit (see illustration). The 'lightning'
power symbol should be above the
water flow 'arrow'.