Connection To The Water Inlet - Miele G 307 Operating Instructions Manual

Plumbing

Connection to the water inlet

Water in the dishwasher must not
be used as drinking water.
The dishwasher may be connected
to a cold or hot water supply, max.
60 °C.
Connection to a hot water supply
would save energy costs and time.
When connected to a hot water sup-
ply all programme stages which
would otherwise be carried out with
cold water (pre-wash and interim
rinse) as well as the COLD PRE-
WASH will be carried out with hot
water.
The inlet hose is approx. 4.5 m long.
A stopcock with a 3/4" male thread
must be provided on site.
The dishwasher is constructed to
comply with DVGW regulations, and
may be connected to a suitable sup-
ply without an extra non-return valve
provided that national regulations
allow this.
The water pressure (flow rate at the
take-off point) must be between 1.0
and 10 bar pressure.
If the water pressure is too low the
water intake time must be increased
(see chapter "Checking the water
level").
If the water pressure is too high, a
pressure reducer valve must be fitted.
66
The water inlet hose must not be
shortened or damaged in any way
(see illustration).
Connect the inlet hose with the
"Waterproof-System" preferably verti-
cally so that the hose exits from the
bottom of the "waterproof valve" box
(use an angle connector if necess-
ary).